GEV Shark
CHF199.–

GEV Shark


Questions about GEV Shark

What would you like to know?

Avatar

0 questions and answers

Avatar

5 days ago

Are there any spare keys?

Avatar

5 days ago

Helpful answer
Unfortunately, replacement keys are not intended for regular sale with this product. I would therefore recommend contacting the manufacturer directly, as they may be able to offer or order certain spare parts directly.
Avatar

1 year ago

Avatar
Galaxus

1 year ago

The "Shark ()" ski rack from GEV is generally designed to be fitted on a variety of cars, but there are some factors that need to be considered to ensure that it will fit on your Peugeot 108. - Support surface width: The ski carrier has a support surface width of 25 cm, which usually fits on most car roofs. - Mounting method: The ski rack is magnetically mounted, which means that it works on metal roofs. Make sure that the roof of your Peugeot 108 is metal and does not have a roof aerial or other obstructions that could interfere with the installation. - Length and height of the car: The Peugeot 108 has a length of 3475 mm and a height of 1460 mm, which is within the typical dimensions on which ski racks can be mounted. As a rule, the ski rack should be able to be mounted on the roof of your Peugeot 108 without any problems as long as the roof surface is made of metal and there are no special obstacles. However, it is always advisable to consult the manufacturer's specific fitting instructions and, if necessary, carry out a test before fitting to ensure that everything fits and is secure.
Automatically generated from the .
Avatar

2 years ago

How do you get them off the car again?

Avatar

2 years ago ‱ purchased this product

purchased this product
Helpful answer
I've been using them for a long time. This wire strap is used to lift the magnetic surface on one side, after which it is very easy to remove the things from the roof.
Avatar

4 years ago

Avatar

4 years ago ‱ purchased this product

purchased this product
Helpful answer
I have already done that. You have to pull on both metal brackets with a lot of force. Two at a time, if necessary. I then ran a thin knife between them. Then it works.
Avatar

4 years ago

Avatar

4 years ago ‱ purchased this product

purchased this product
Helpful answer
It would work, but only for 2skis + 2snow or 4snow. It only opens to one side (to the left), so to open and close the skis section would be complicated from the non-drivers side. 4snow would be ok since it uses rubber bands to fix them instead of the key system.
Avatar

4 years ago

Avatar

4 years ago ‱ purchased this product

purchased this product
I've had the ski rack for two years and for the price, of course, I got one rack for the front and one for the rear.
Avatar

7 years ago

can it fit on a 2012 mazda 2 model?

Avatar

7 years ago ‱ purchased this product

purchased this product
Helpful answer
Yes I don't see the problem with this suction cup, I have a Suzuki SWIFT and it goes very well on it.
Avatar

8 years ago

Avatar

8 years ago ‱ purchased this product

purchased this product
There is only one safety line for the front and one for the rear car door. This is "fixed" either on the driver's or the passenger's side. Roof rails should not be a problem in my opinion. The roof must be flat only where the carrier is mounted (magnetically "glued").
Avatar

8 years ago

Avatar

8 years ago ‱ purchased this product

purchased this product
Helpful answer
Hi Patnal74, unfortunately that won't work. Especially the 22 cm won't be enough and the bent sheet metal won't hold. I had the same problem and had to return the carriers. Many greetings
Avatar

9 years ago

Avatar

9 years ago ‱ purchased this product

purchased this product
Helpful answer
I have looked at the operating instructions again, but have not found anything that speaks against it. Only the maximum permitted roof load, but this should not be limiting (in my case 50 or 75 kg).

28 of 28 questions

To Top