Delphin Spa Whirlpool Tub Pipe Cleaner 1L

In the piping system of whirlpool baths and hot tubs, small dirt particles can accumulate. Often, these deposits form a so-called biofilm, which can serve as a breeding ground for bacteria, germs, and Legionella. DELPHIN Spa Pipe Cleaner mechanically removes this biofilm and cleans the piping system.

Dosage in the whirlpool bath:
125 ml per 100 l of water. Use the pipe cleaner regularly, but no later than after eight applications or two months, whichever comes first.

Dosage in the hot tub:
300 to 500 ml per 1,000 l of water, depending on the level of contamination and foam formation.

Application:
The whirlpool bath or hot tub must be filled to about 5 to 10 cm above the jets. Ensure that the air massage is turned off. Now start the bubbling system. After about 10 minutes, you can turn off the bubbling function and drain the water. Then rinse the tub with clean water.

Note:
In case of excessive foam formation during application, add 100 to 150 ml of DELPHIN Spa Defoamer directly to the water.

Signal word: Danger

Hazard statements H-statements:
H314 Causes severe skin burns and eye damage.
H400 Very toxic to aquatic life.

Safety statements P-statements:
P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P260 Do not breathe mist, vapors, or spray.
P280 Wear protective gloves and eye protection.
P303+361+353 IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower.
P305+351+338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing.
P405 Store locked up.
P501 Dispose of contents/container in accordance with local, regional, national, or international regulations.