Light my bricks RGB IR remote control board

This RGB board is a small circuit board with two outputs and a built-in IR sensor to remotely control Light my Bricks RGB Bit lights and RGB strip lights. Important note: This RGB component is only compatible with other components from the Light my Bricks RGB range. Simply add this to your existing lighting circuit via a standard connection cable or connect your power source directly to the IN terminal (+5 V). Light my Bricks RGB lights can project nine different colors and can be connected either directly or through the Light my Bricks RGB expansion board with the two built-in OUT terminals. Set the desired color or effect using the included remote control for the RGB board. The default setting on the RGB board is off, even if the other components in your lighting set are turned on. To control the RGB lights, point the remote control at the RGB board and turn on the lights using the ON button. Select the desired color by pressing one of the colored buttons. You can also control the brightness and choose one of the following effects: Flash - strobe light effect in your chosen color, Strobe - blinks rapidly while cycling through all colors, Fade - cycles through all colors, three seconds for each color, Smooth - cycles through all colors, seven seconds for each color. Light my Bricks offers LEGO fans an easy way to enhance their LEGO models with LED lights. All components in the Light my Bricks sets are plug-and-play capable - no electronics knowledge is required for installation.