Molto Moisture Blocker

For the insulation of damp and wet walls. Ideal for insulating damp and wet walls indoors and outdoors. Also for sealing moisture in masonry, on plastered walls, on concrete, in basement areas, on foundations, in damp rooms such as bathrooms, showers, kitchens, on retaining walls, wells and Pflanzentrögen. Applicable on all mineral substrates that do not contain gypsum. E.g. on masonry made of sand-lime bricks, aerated concrete blocks, bricks, etc. Molto Moist Blocker can be applied above and below ground and can also be applied on slightly damp substrates. Application: The substrate must be sufficiently solid and load-bearing and free from adhesion-reducing layers such as dust, dirt and loose parts. Close cracks, holes and unevenness with a suitable Molto powder filler. Strengthen slightly sanding plaster layers with Molto Deep Primer. Remove salt efflorescence from the masonry with Molto Saltpetre Remover. Prevent the penetration of further moisture into the masonry by professional measures. Shake Molto Moist Blocker well for at least one minute before use - the product is ready for use. Spray on the layers evenly. As a rule, two coats are sufficient. If the substrate is very porous, three coats should be applied. Before applying the second or third coat, the previous coat must be thoroughly dry. After drying, Molto Moist Blocker can be painted over with alkali-resistant emulsion paints. Ingredients: Acrylic resin, titanium dioxide, fillers, solvents, additives.