Hammerite Protective metal lacquer
750 ml, Dark greenColour5
In Detail
Direct-to-Rust Metal Protection Paint. Hammerite Direct-to-Rust Metal Protection Paint serves as a primer, undercoat, and topcoat all in one. Dualtech provides double protection: water beads off and rust is halted – the metal remains resilient for longer. Pre-treatment: Sand smooth surfaces, remove loose rust and peeling old paint with a wire brush. Clean dirt, dust, and grease residues with diluted detergent. Rinse with clear water and allow to dry thoroughly.
Apply Hammerite Direct-to-Rust Metal Protection Paint to a small, already painted area and let it dry for 1 hour. If there is no reaction, apply Hammerite Direct-to-Rust Metal Protection Paint to the entire surface. If a reaction occurs, remove all old paint before applying Hammerite Direct-to-Rust Metal Protection Paint. For bare zinc, aluminum, and galvanized surfaces, treat the relevant areas with Hammerite Special Adhesion Primer before applying Hammerite Direct-to-Rust Metal Protection Paint. Application: Brush application: Ideal processing temperature is between 11°C and 25°C. Stir lightly before use. Apply undiluted. For pre-painted metal surfaces in good condition, one coat is sufficient. For bare, rusty metal, two coats are required. Ensure that all corners and edges are well covered. Do not apply too thickly, as this may cause runs. Contains: Alkyd resin, solvents, fillers, pigments, additives. After approximately 1 to 2 hours, it is dust dry (spray can may vary). Repaintable after 4 hours (spray can may vary). Coverage: 1 liter covers approximately 5 m² (spray can may vary).
GHS07 Health hazard
GHS02 Flammable- H412 Harmful to aquatic life with long-lasting effects.
- H336 May cause drowsiness or dizziness.
- H226 Flammable liquid and vapour.




