Bayrol Quick Test

Test strips for analyzing the water in your pool and measuring the parameters pH, TAC, as well as chlorine and algaecide concentration. Easy and quick to use.

Quicktest allows for a simple and fast analysis of pool water. These test strips measure four important parameters simultaneously and in just a few seconds: pH value, TAC, chlorine, and algaecide.

The Quicktest strips contain four reagent squares for the parameters mentioned above. When the squares come into contact with water, they change color according to the parameter values. These values can then be easily determined by comparing them to a reference color chart. Once deviations are identified, they should be corrected with appropriate products.

Use this product only according to the instructions.

• Immerse the test strip completely in water for five seconds, moving it around, and then remove it. Do not shake the test strip. Immediately check the pH value by comparing the color with the color chart printed on the tube. If necessary, adjust the pH value with pH Minus or pH Plus.

• Wait another ten seconds and then check the values for free chlorine and alkalinity (TAC) by comparing the color of each stamp with the color chart printed on the tube. If the TAC value is too low, i.e., below 80 mg/L, increase it with Alca Plus.

• For algaecide measurements, immerse the test strip a second time in water for 45 seconds (do not stir!) and then remove it. Immediately check the algaecide value by comparing it with the color scale.