Digi XBee 2mW Wire Antenna Series 2 (ZigBee Mesh)

This is the XBee XB24-Z7WIT-004 module from Digi. Series 2 improves on
the power output and data protocol. Series 2 modules allow you to
create complex mesh networks based on the XBee ZB ZigBee mesh
firmware. These modules allow a very reliable and simple communication
between microcontrollers, computers, systems, really anything with a
serial port! Point to point and multi-point networks are supported.

These are essentially the same hardware as the older Series 2.5, but
have updated firmware. They will work with Series 2.5 modules if you
update the firmware through X-CTU.

Note: If you are looking for a simple point-to-point configuration,
you might want to try the Series 1 instead. The Series 2 requires
considerable setup and configuration.

Note: Series 1 and Series 2 XBee modules have the same pin-out.
However, Series 1 modules cannot communicate with Series 2 modules.

Features:

* 3.3V @ 40mA
* 250kbps Max data rate
* 2mW output (+3dBm)
* 400ft (120m) range
* Built-in antenna
* Fully FCC certified
* 6 10-bit ADC input pins
* 8 digital IO pins
* 128-bit encryption
* Local or over-air configuration
* AT or API command set

Documents:

* Digi XBee Series 2 Page [1]
* Digi Examples and Guides [2]
* X-CTU Software [3]

Links:

• -----

[1]
http://www.digi.com/support/productdetl.jsp?pid=3430&osvid=0&s=365&tp=3
[2] http://examples.digi.com/
[3] http://www.digi.com/support/productdetail?pid=3352