Eltako Switch actuator RS485 bus actuator 2 channel current impulse switching relay noiseless

Silent pulse relay with 2 channels, 400 W. 2 solid-state relays, not potential-free. Bidirectional. Standby loss is only 0.1 watts. Connection to the Eltako RS485 bus. Cross-wiring of bus and power supply with a jumper. If both relays of the FSR14 are activated, 0.4 W is required. The rated switching power of 400 W applies to one contact and also as the sum of both contacts. Connecting multiple devices in parallel for power increase is permitted. From manufacturing week 12/17, it features automatic electronic over-temperature shutdown. For loads less than 1 W, a GLE must be connected in parallel to the load. In the event of a power failure, it will be defined as switched off. The channels can be learned independently as ES and/or ER channels. Scene control: With one of the four control signals from a button learned as a scene button with a double rocker, multiple channels of one or more FSR14SSR can be turned on or off for each scene. Central commands from a PC are sent using the building radio visualization and control software GFVS. To do this, one or more FSR14SSR must be learned on the PC. The rotary switches are used to learn the buttons and, if necessary, test the 2 channels. For normal operation, the middle and lower rotary switches are then set to AUTO. The upper rotary switch is used to set the EW time (0-120 seconds) for relays or the RV time (0-120 minutes) for pulse switches equally for all channels if necessary. When radio motion brightness sensors FBH (Master) and/or FBH (Slave) are learned, the switching threshold for each channel is set with the upper rotary switch, at which the lighting is turned on or off. Settings for the upper rotary switch are according to the operating manual.