Good evening, I bought the WD Blue 3D NAND (1000GB, M.2 2280) a few days ago to upgrade my C drive to 1TB. When cloning the existing SSD, I noticed an extremely slow write speed. I then did a speedtest with AS SSD Benchmark with 10GB. At the beginning, the write speed was 256MB/s, but this quickly changed continuously downwards to only 1MB/s. I had to stop the test because the write speed was too slow. I then had to stop the test because it would have taken x hours for the 10GB. I also checked the SSD for errors with check disk. No errors were found. Is the SSD broken? Greetings Niels
Zorro44
5 years ago
Hello, does the tool for cloning also support SSD? When writing, the fast memory SLC is used first, then the slower memory TLC or QLC is used internally.

Question

Good evening, I bought the WD Blue 3D NAND (1000GB, M.2 2280) a few days ago to upgrade my C drive to 1TB. When cloning the existing SSD, I noticed an extremely slow write speed. I then did a speedtest with AS SSD Benchmark with 10GB. At the beginning, the write speed was 256MB/s, but this quickly changed continuously downwards to only 1MB/s. I had to stop the test because the write speed was too slow. I then had to stop the test because it would have taken x hours for the 10GB. I also checked the SSD for errors with check disk. No errors were found. Is the SSD broken? Greetings Niels

5 years ago

Hello, does the tool for cloning also support SSD? When writing, the fast memory SLC is used first, then the slower memory TLC or QLC is used internally.

Answer

Hello, does the tool for cloning also support SSD? When writing, the fast memory SLC is used first, then the slower memory TLC or QLC is used internally.

Search

Settings

Customer account

Comparison lists

Watch lists

Cart

Question about WD Blue