CHF25.70
Netgear Gs105e-200pes
5 Ports
Questions about Netgear Gs105e-200pes
What would you like to know?
0 questions and answers
The switch should work with it without any problems. What exactly gives you a stomach ache about the switch?
Helpful answer
According to our supplier, it should be version v2.
no, this must be done on the end device or router. switchports never have ip addresses
Hey Cynthíon Unfortunately, I have not read anything about PoE for this device, neither from the manufacturer nor from another online shop. Therefore, I assume that this device does not support PoE.
Of course Netgear wants you to have an original part. Here are the data from the original. In: 220V, 0.2 A, Out: 12V, 1 A. + on pin in the centre. Good luck finding an alternative.
Helpful answer
Hello Velogemp, the switch can only be configured via the web after the firmware upgrade. Initial configuration must be done via Netgear Utility. For this, the switch needs an IP address that it obtains via DHCP. Does the router give the switch an IP address? If not, it cannot be found. Mfg thommybee
Helpful answer
Yes, it should work. It supports the IGMP snooping required for the Swisscom Box.
Yes, the switch has a WebGUI through which it can be configured.
Helpful answer
It's an "unmanaged PLUS" switch (can also be seen in the specs): So it has basic management funktionalities: http://www.netgear.co.uk/business/products/switches/unmanaged-plus/gigabit-plus-switch.aspx "On top of the plug-N-play Gigabit Ethernet connectivity, these switches also offer essential networking features such as VLAN, QoS, IGMP Snooping, Link Aggregation (LAG), rate limiting and traffic monitoring. "
11 of 11 questions