Brodit Passive Mount with Ball Joint Amazon Kin

Passive holder with tilt swivel

With your Kindle Fire in a holder attached in the car, you will always have it within easy reach. Safe, neat, and convenient! You can connect a charging cable to the Kindle Fire when it is in the holder.

The holder is mounted onto a tilt swivel. This means that you can adjust the angle to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into the desired position. It is easy to put the Kindle Fire into place in the holder and to take it with you when leaving the car.

Installation instructions:

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, while tightening the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still adjustable.

3. To place the device in the holder: Place the lower part of the device in the holder, then flip or press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, while pulling the upper part of the device out from the holder, and then lift the device up and out from the holder.

4. The holder is in place.