Brodit Active holder BlackBerry Classic

Active holder with cig-plug
With tilt swivel. With USB cable.

The active holder charges your Blackberry Classic when it is in the holder. If you have a car with a USB interface, you can disconnect the cig-plug from the holder's cable to connect directly to the USB connector in your vehicle.

The holder is attached to a tilt swivel and can be adjusted to avoid light reflection. It connects to the vehicle’s cigarette lighter socket, 12 Volt. Attach it onto a ProClip Mounting Platform.

Important note!

In order to transmit audio files from your device through the USB cable, this feature must be supported by the stereo in your car. This can be easily tested by connecting your device to the stereo with the USB/charging cable that comes with your device. Charging through USB works regardless.

INSTALLATION INSTRUCTIONS:
Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, while tightening the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

4. The holder is in place.