ESU ECoS Detector Out Extension

If necessary, any ECoSDetector can be supplemented with an ECoSDetector extension module, which can be easily connected to the ECoSDetector. Each ECoSDetector extension module provides 32 transistor outputs.

Outputs
Each of the 32 outputs delivers a maximum current of 100 mA. Since these outputs are designed as open collectors, you can directly connect either small bulbs or LEDs with a current-limiting resistor.

The total current of all outputs must not exceed 1.5 A. Any DC or AC transformer (15V - 19V) can be used for operation.

Track Occupancy and Block Signals
The outputs can be used to externally indicate the status of each individual track section (for example, on the track control panel). Alternatively, you have the option to display the status of each track section via a block signal (red/green) on the display.

The transistor outputs of the ECoSDetector extension module can be easily programmed in the required operating mode via your ECoS command station.

Track Control Panel
However, the combination of the ECoSDetector and the extension module offers even more: you can build your own track control panel! To enable this, you need to connect push buttons or toggle switches to the outputs of the ECoSDetector, which can then control turnouts and tracks via the command station.

The transistor outputs of the extension module are intended for lighting track sections. The entire configuration process can be easily completed through the display of your ECoS command station.

If you want to build a larger track control panel, you can also combine multiple ECoSDetector modules. This allows you to create and control up to 100 track control panels per layout.