Hammerite Metal protective lacquer matt white

Hammerite Direct-to-Rust Metal Protection Paint is a primer, undercoat, and topcoat all in one. DUALTECH provides double protection: water beads off and rust is stopped – the metal stays resilient for longer.

Preparation:
Sand smooth surfaces, remove loose rust and flaking old paint with a wire brush. Clean dirt, dust, and grease residues with diluted cleaning agent. Rinse with clear water and allow to dry thoroughly. Apply Hammerite Direct-to-Rust Metal Protection Paint to a small, already painted area and let it dry for 1 hour. If there is no reaction, apply Hammerite Direct-to-Rust Metal Protection Paint to the entire surface. If a reaction occurs, remove all old paint before applying Hammerite Direct-to-Rust Metal Protection Paint. For bare zinc, aluminum, and galvanized surfaces, treat the relevant areas with Hammerite Special Adhesion Primer before applying Hammerite Direct-to-Rust Metal Protection Paint.

Application:
Painting method: Ideal application temperature is between 11°C and 25°C. Stir lightly before use. Apply undiluted. One coat is sufficient for pre-painted metal surfaces in good condition. Two coats are required for bare, rusty metal. Ensure that all corners and edges are well covered. Do not apply too thickly, as this may lead to drips.

Contains: Alkyd resin, solvents, fillers, pigments, additives. Dust dry in about 1 – 2 hours (spray can may vary). Repaintable after 4 hours (spray can may vary). Coverage: 1 liter is sufficient for approximately 5 m² (spray can may vary).