Hammerite Metal protective lacquer matt anthracite

Direct-on-rust metal protection lacquer
Hammerite direct-on-rust metal protection lacquer is a primer, undercoat and topcoat in one. DUALTECH provides 2-fold protection: water beads off and rust is stopped - the metal remains resistant for longer.
Pre-treatment:
Sand smooth surfaces, remove loose rust and flaking old coats with a wire brush.
Remove dirt, dust and grease residues with diluted cleaning agent. Rinse with clear water and allow to dry thoroughly.
Apply Hammerite Direct-to-Rust Metal Protective Paint to a small, already painted surface and allow to dry for 1 hour. If no reaction occurs, apply Hammerite Direct On Rust Metal Protective Paint to the entire surface. If a reaction occurs, remove all old paint before applying Hammerite Direct On Rust Metal Protective Paint.
On bare zinc, aluminium and hot-dip galvanised surfaces, treat the surfaces concerned with Hammerite special primer before applying Hammerite direct-on-rust metal protection lacquer.
Application:
Brushing method: Ideal application temperature 11°C to 25°C. Stir lightly before use.
Apply undiluted. On pre-painted metal surfaces in good condition, 1 coat is sufficient. On bare, rusty metal, 2 coats are required. Ensure that all corners and edges are well covered. Do not apply too thickly or run-off will occur.
Contains: Alkyd resin, solvents, fillers, pigments, additives.
Dust-dry after approx. 1 - 2 hours (spray can differs).
Can be painted over after 4 hours (spray can differs).
Consumption: 1 l is sufficient for approx. 5 m2 (spray can differs).