Avisa Stainless steel bumper protection for VW ID.3 from 2019 until today

High-quality loading edge protection made of brushed stainless steel for the rear bumper.

The strip protects the bumper from mechanical damage to the top, which is used during loading and unloading. Additionally, the strip, thanks to its specially profiled edge, protects the edge of the bumper.

Ideal as protection for the bumper or to cover existing scratches.

• The strip is mounted over the rear bumper
• Material: Made of high-quality stainless steel (brushed)
• Absolutely rust-free
• Adhesive strips attached to the back; installed in just a few minutes
• Vehicle-specific, highest precision fit, with edge profile
• Elegant and modern appearance
• Visual enhancement of the vehicle's rear

Installation instructions:

• Before removing the protective film from the adhesive tape, check if the loading edge protection is suitable for the area to be covered.
• For installation, it is important that the area to be covered on the vehicle is clean, dry, and free of grease.
• The loading edge protection is applied using the pre-mounted adhesive strips on the back.
• Please ensure that the loading edge protection is aligned flush from the start. To center it, you can use the latch alignment on the trunk floor as a guide.
• Then press down several times, and you're done!.