Avisa Stainless steel bumper protection for VW Golf 7 Sedan from 2012 until today

High-quality stainless steel loading edge protection for VW Golf 7 sedan from 2012 to present.

The loading edge protection made of brushed stainless steel protects the rear bumper from mechanical damage that can occur during loading and unloading. Additionally, the specially profiled edge preserves the edge of the bumper.

Ideal as protection for the bumper or to cover existing scratches.

• Strip is mounted over the rear bumper
• Material: Made of high-quality stainless steel (brushed)
• Absolutely rust-free
• Adhesive strips attached to the back; installed in just a few minutes
• Vehicle-specific, highest precision fit, with edge profile
• Elegant and modern appearance
• Enhances the aesthetics of the vehicle's rear

Installation instructions:

• Before removing the protective film from the adhesive tape, check if the loading edge protection is intended for the area to be adhered.
• For installation, it is important that the area to be adhered on the vehicle is clean, dry, and grease-free.
• The loading edge protection is applied using the pre-mounted adhesive strips on the back.
• Please ensure that the loading edge protection is aligned flush from the start. To center it, you can use the latch alignment on the trunk floor as a guide.
• Then press down several times, and you're done!.