Avisa Stainless steel bumper protection for Audi Q3 RS Sportback from 2019 until today

High-quality stainless steel loading edge protection for Audi Q3 RS Sportback from 2019 to present.

The loading edge protection made of brushed stainless steel protects the rear bumper from mechanical damage that can occur during loading and unloading. Additionally, the specially profiled edge protects the edge of the bumper.

Ideal as protection for the bumper or to cover existing scratches.

• The strip is mounted over the rear bumper
• Material: High-quality stainless steel (brushed)
• Absolutely rust-free
• Adhesive strips attached to the back; installed in just a few minutes
• Vehicle-specific, highest precision fit, with edge profile
• Elegant and modern appearance
• Visual enhancement of the vehicle's rear

Installation note:

Before removing the protective film from the adhesive tape, check whether the loading edge protection is intended for the area to be covered. For installation, it is important that the area to be covered on the vehicle is clean, dry, and grease-free. The loading edge protection is adhered using the pre-mounted adhesive strips on the back. Ensure that the loading edge protection is aligned flush from the start. To center it, you can use the latch alignment on the trunk floor as a guide. Then press down several times, and you're done!.