Avisa Stainless steel bumper protection for Audi Q3 from 2011 to 2018

High-quality stainless steel loading edge protector for Audi Q3 from 2011 to 2018.

The loading edge protector made of brushed stainless steel protects the rear bumper from mechanical damage that can occur during loading and unloading. Additionally, the specially profiled edge protects the edge of the bumper.

Ideal as protection for the bumper or to cover existing scratches.

The strip is mounted over the rear bumper.
Material: High-quality brushed stainless steel.
Absolutely rust-free.
Adhesive strips attached to the back; installed in just a few minutes.
Vehicle-specific, highest precision fit with edge profile.
Elegant and modern appearance.
Enhances the visual appeal of the vehicle's rear.

Installation instructions:

Before removing the protective film from the adhesive tape, check whether the loading edge protector is suitable for the area to be covered.
For installation, it is important that the area to be covered on the vehicle is clean, dry, and grease-free.
The loading edge protector is applied using the pre-mounted adhesive strips on the back.
Ensure that the loading edge protector is aligned flush from the start. To center it, you can use the notch of the lock on the trunk floor as a reference.
Then press down several times, and you're done!.