Avisa Stainless steel bumper protection for Audi A4 Avant (estate) from 2012 to 2015

High-quality stainless steel loading edge protection for Audi A4 Avant (station wagon) from 2012 to 2015.

High-quality loading edge protection made of brushed stainless steel for the rear bumper.

The strip protects the bumper from mechanical damage to the top, which is used during loading and unloading. Additionally, the strip protects the edge of the bumper thanks to its specially profiled bend.

Ideal as a protection for the bumper or to cover existing scratches.

The strip is mounted over the rear bumper.
Material: Made of high-quality stainless steel (brushed).
Absolutely rust-free.
Adhesive strips on the back; can be applied in just a few minutes.
Vehicle-specific, highest precision fit, with bending.
Elegant and modern appearance.
Visual enhancement of the vehicle's rear.

Installation instructions:

Before removing the protective film from the adhesive tape, check whether the loading edge protection is intended for the area to be covered.
For installation, it is important that the area to be covered on the vehicle is clean, dry, and grease-free.
The loading edge protection is applied using the pre-mounted adhesive strips on the back.
Please ensure that the loading edge protection is aligned flush from the start. To position it centrally, you can use the latch alignment on the trunk floor as a guide.
Then press down several times, and you're done!.