I connected the Hama device to a Yamaha A s-801 amplifier (USB connection). I wanted to listen to music via the laptop through the stereo system. Does not work. Followed the instructions. RX control set correctly. What am I doing wrong?

Question

Answer

Der USB Anschluss ist meines Wissens nur zum Laden da. Sie brauchen das 3.5mm Jack audio Kabel, und falls Sie das Gerät nicht gepaart haben mit dem PC, so hilft die untenstehende Anleitung (aus dem original Manual)

• Connect your terminal device to the adapter using the included 3.5 mm jack cable and the audio
connection (AUX) (4).
• Select the adapter’s RX mode by moving the switch (1) to the right.
• The adapter and the terminal device should be no further than 1 metre apart. The shorter the
distance, the better.
• With the adapter on, press the multifunction button (2) twice. After approximately 3 seconds, the
status LED (3) will emit flashes of alternating blue and red light to indicate the device is in pairing
mode.
• Open the Bluetooth® settings on your terminal device and wait until BTI-020V appears in the list
of Bluetooth® devices found.

Ich hoffe es hat geklappt. Denn wenn es gepaart ist, funktioniert das Gerät meiner Erfahrung nach perfekt. Viel Spass damit.

Search

Question about Hama Bluetooth audio transmitter/receiver

I connected the Hama device to a Yamaha A s-801 amplifier (USB connection). I wanted to listen to music via the laptop through the stereo system. Does not work. Followed the instructions. RX control set correctly. What am I doing wrong?