I bought such a device and am now trying to send an audio signal to two identical iFrogz Coda headphones at the same time, which should be possible according to the specification. Unfortunately, it just doesn't work!
Does anyone have experience with such a case?

Question

Accepted Answer

Hello, 
Have you already paired the two headphones? 
If so, please disconnect both again and delete the pairing list of the adapter to be on the safe side. 
To do this, switch off the adapter in the current mode (TX or RX). After about 3 seconds, set the switch (1) to the other mode and switch the adapter on again. All paired devices are now deleted from the list. 

Now connect the two headphones to the adapter at the same time: 
- Select the TX mode of the adapter by moving the switch (1) to the left. 
- Switch on the two headphones and activate the pairing mode. 
- The adapter and the headphones should not be more than 1 metre apart. 
- Press the multifunction button (2) of the switched-on adapter twice. After approx. 3 seconds, the status LED (3) flashes blue to indicate pairing mode. 
- The adapter automatically names the two terminals A and B and establishes a connection. 

Greetings 
Andy from Hama 
Follow Hama: 
instagram.com/hama_schweiz/ 
http://www.facebook.com/Hama.Technics.Schweiz

Search

Question about Hama Bluetooth audio transmitter/receiver

I bought such a device and am now trying to send an audio signal to two identical iFrogz Coda headphones at the same time, which should be possible according to the specification. Unfortunately, it just doesn't work! Does anyone have experience with such a case?