Hello, do any of you have the UDM PRO with Wingo Fiber running? I have added the tp-link-tl-sm321b module and set the VLAN ID on the WAN port to 10. Still doesn't seem to work.

Question

Accepted Answer

You have to update the firmware first, the unit has a problem with direct fibre connections via SFP module for setup. After the firmware update, this should work. I had the same issue.  See the manual at Ubiquiti. The problem also exists with a media converter, because by default for the setup it somehow only works via WAN1 (SFP+ slot) and not via WAN2 (RJ45). 

1: Download firmware from the UI site (the current version is 1.8.3, which then includes Unifi 6.0.41).
2: Copy via SCP to the unit
3: SSH to the unit, upgrade the firmware.
4: Run the setup again
5: Voilà

Oh yes, it is best to unplug the HDD (if there is one in it). 

Tip: Sometimes it helps to have a little patience while waiting for an internet connection. I was 
I was a bit too fast a few times and could have had the solution sooner. 

https://community.ui.com/questions/UDM-Pro-Firmware-upgrade-issues-via-SSH/1f5b4794-07de-4238-adf2-9f71e426a7cc

A bloody chicken-and-egg problem.

Answer

I would also be interested, I have the same problem with Teleboy.

Search

Question about Ubiquiti UniFi Dream Machine Pro

Hello, do any of you have the UDM PRO with Wingo Fiber running? I have added the tp-link-tl-sm321b module and set the VLAN ID on the WAN port to 10. Still doesn't seem to work.