CHF91.90
Thermaltake Riing Plus 14 RGB TT Premium Edition
140 mm, 3 x
Question about Thermaltake Riing Plus 14 RGB TT Premium Edition
Does anyone else have the error code H_0x0001? I can't control the fans. The LED is running and the fans are also running, but only at maximum speed.
I also had the same problem with the programme. The following helped me:
1. disconnect the controller from the power supply (while the PC is running)
2. wait a few seconds
Plug the controller back in.
1. disconnect the controller from the power supply (while the PC is running)
2. wait a few seconds
Plug the controller back in.
I was able to solve the problem. Some of the PINS on the Molex connector were pushed out of the holder. After plugging in the Molex connector correctly, everything worked perfectly.
I also had this problem. But after I reset the BIOS, the problem was solved.
I have an i7 6850k. The problem is that I can't change anything in the software because the error code is permanently displayed in the front. My controller is not recognised, so to speak. I've read a lot about this problem but haven't found a solution yet. Installed and uninstalled several times. Tried different USB headers etc......
Same problem, I have connected the fans via this controller, but I always get this error. Is there already a solution to this?
