Eltako Impulse switch

Potential-free relay 16A/250V AC, 230 V LED lamps up to 600W, incandescent lamps 2000W. No standby loss. Modular device for mounting on DIN rail EN 60715 TH35. 1 module = 18mm wide, 58mm deep. With the patented Eltako duplex technology (DX), the normally potential-free contacts can still switch at the zero crossing when switching 230V AC at 50Hz, drastically reducing wear. Simply connect the neutral conductor to terminal (N) and the live conductor to terminal 1(L). This results in a standby loss of only 0.1 watts. If the contact is used to control devices that do not switch at the zero crossing, (N) should not be connected, as the additional closing delay would have the opposite effect. Control voltage 110V AC - 240V AC at control input A1/A2. Very low switching noise. No continuous power supply required, hence no standby loss. State-of-the-art hybrid technology combines the advantages of wear-free electronic control with the high performance of special relays. By using a bistable relay, there is no coil loss and no heating even in the switched-on state. The relay contact can be open or closed at startup and synchronizes on the first operation. The terminal assignment is identical to the electromechanical impulse switch S12-100-. If this impulse switch is in a circuit monitored by a field disconnector, no additional base load is required. However, the monitoring voltage must be set to maximum, and control is only via A1-A2.