Eltako FSR71NP-4x-230V

Power pulse relay with 4 channels, each with 1 normally open contact, not potential-free, rated for 4A/250V AC. Features light scene control via PC or wireless switches. Encrypted wireless, bidirectional communication, and repeater function can be activated. Standby loss is only 0.8 watts. Designed for installation in the 230V power supply line, such as in suspended ceilings and light fixtures. Dimensions: 166 mm long, 46 mm wide, and 31 mm high. Equipped with cable strain relief. In the event of a power failure, it will turn off as defined. The channels can be programmed independently as ES or ER channels. Scene control: With one of the four control signals from a button programmed as a scene switch with a double rocker, multiple channels of one or more FSR71NP-4x can be turned on or off as a single scene. Central commands from the PC are sent using the building wireless visualization and control software GFVS. To do this, one or more FSR71NP-4x must be programmed on the PC. The rotary switches are used to program the buttons and, if necessary, test the 4 channels. For normal operation, the middle and lower rotary switches are then set to AUTO. The upper rotary switch is used to set the EW time (0-120 seconds) for relays or the RV time (0-120 minutes) for pulse switches uniformly for all channels, if necessary. When wireless motion brightness sensors FBH (Master) and/or FBH (Slave) are programmed, the upper rotary switch is used to set the switching threshold for each channel separately, at which the lighting will be turned on or off. Settings for the upper rotary switch are according to the operating manual. When wireless brightness sensors FAH60 are programmed, the upper rotary switch is used to set the switching threshold for each channel separately, at which the lighting will be turned on or off depending on brightness (from approximately 0 Lux in position 0 to approximately 50 Lux in position 120). A hysteresis of about 300 Lux between on and off is preset.