Product details
2-stage response delay, 1+1 potential-free normally open contacts rated for 10A/250V AC, suitable for 230V LED lamps up to 200W and incandescent lamps up to 1000W. Standby loss is only 0.4 watts. This is a modular device designed for mounting on DIN rail EN 60715 TH35. One modular unit = 18mm wide, 58mm deep. The latest hybrid technology combines the advantages of wear-free electronic control with the high performance of special relays. Universal control voltage of 12..230V UC. Supply voltage is the same as the control voltage. Contact position indication with two LEDs. Very low switching noise. The use of bistable relays ensures that there is no coil loss and no heating even when in the switched-on state. After installation, wait for the automatic short synchronization before connecting the switched load to the power supply. In the event of a power failure, it will be turned off in a defined manner. When the control voltage is applied, the timing T1 starts, lasting between 0 and 60 seconds. At the end of T1, contact 1-2 closes, and timing T2 begins, also lasting between 0 and 60 seconds. At the end of T2, contact 3-4 closes. After an interruption, the timing starts again with T1.