This is the MiniGen Signal Generator, a small shield for the Arduino
Pro Mini that is capable of generating sine, square, or triangle waves
at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is
technically a shield it can, in fact, operate as a stand-alone board
capable of the the same functionality as it would if it were placed on
top of a Pro Mini.
The MiniGen offers two out put sources for you to utilize: a 2-pin
0.1" spaced header and a u.FL connector. The output is at a DC offset
of Vcc/2, however neither the offset nor the amplitude can be varied.
By default, the MiniGen ships configured with a 3.3V regulator enabled
and should only be used with 3.3V signals (or 3.3V Pro Minis if you
are using this as a shield) unless the jumper on the back is soldered
over to bypass the regulator for 5V use.
* 10-bit DAC for good accuracy
* 2 frequency registers
* 2 phase registers
* SPI Interface Driven at 40MHz
* Operating Voltage: 3.3V (5V when jumper is soldered)
* Arduinio Library @Github 
 https://github.com/sparkfun/MiniGen … more
|Product type||Electronics module|
If you wish to learn more about this product, please visit the manufacturer's website or contact us: firstname.lastname@example.org
Warranty 24 month Bring-in
Limited right of return
Please use our simplified returns and warranty process to return a product or register a warranty case. Returns and warranty
Please use our simplified warranty process to view the warranty period as well as any warranty extensions you may have purchased. This will ensure that your return or warranty case is processed quickly and effectively.
Information subject to change.
Have you tested this product? Share your opinion with the Galaxus community.Rate product
You're not connected to the Internet. Please check that your connection is enabled to keep browsing the site.