This Kit contains necessary electronic modules and accessories for you
to build simple robots.
The baseboard intergrates an Arduino Leonard core and two channel
motor driver, the motor
driver IC is TB6612,which is a high efficence
motor driver with peak current up to 3A. The baseboard can provide
high current up to 5V/3A, which means you can use the board to drive
some high-power modules such as servo motors and LED strip.
With this kit, you can build a IR control robot, a line following
robot, or a obstacle avoidance robot. by using this kit, wiring is
very easy and intuitive, you can focus on your ideas.
We also provide a RJ25 to 2.54mm pin adapter, which can be used to
connect Makeblock electronic modules with other ordinary electronic
modules, this adaptor can also be used to control 2 servo motors.
* 1 x Me-Baseboard
* 1 x Me-Ultrasonic Sensor
* 1 x Me-Line Finder
* 1 x Me-IR Receiver
* 1 x Me-IR Remote Controller
* 2 x 6P6C RJ25 cable-20cm
* 1 x 6P6C RJ25 cable-35cm
* 1 x USB 2.0 A-Male to Micro B-Male Cable
* 2 x Base Bracket
* 1 x Battery Holder for (6)AA
* 10 x Socket Cap Screw M4x8
* 4 x Nylon Stud M4*30
* 10 x Plastic Rivet R4060
* 4 x Plastic Rivet R4100
If you want to know more about above electronic modules, please visit
Makeblock wiki page . Note: The battery of IR Remote Controller
will be taken to assure safe transport, you may need to buy it by
yourself. The battery size is CR2025. Sorry about the inconvenience.