Feather is the new development board from Adafruit, and like it's
namesake it is thin, light, and lets you fly! We designed Feather to
be a new standard for portable microcontroller cores.
This is the Adafruit Feather HUZZAH ESP8266 - our take on an
'all-in-one' ESP8226 WiFi development board with built in USB and
battery charging. Its an ESP8266 WiFi module with all the extras you
need, ready to rock!
At the Feather HUZZAH's heart is an ESP8266 WiFi microcontroller
clocked at 80 MHz and at 3.3V logic. This microcontroller contains a
Tensilica chip core as well as a full WiFi stack. You can progam the
microcontroller using the Arduino IDE for an easy-to-run Internet of
Things core. We wired up a USB-Serial chip that an upload code at a
blistering 921600 baud for fast development time. It also has
auto-reset so no noodling with pins and reset button pressings.
To make it easy to use for portable projects, we added a connector for
any of our 3.7V Lithium polymer batteries and built in battery
charging. You don't need a battery, it will run just fine straight
from the micro USB connector. But, if you do have a battery, you can
take it on the go, then plug in the USB to recharge. The Feather will
automatically switch over to USB power when its available.
Here's some handy specs! Like all Feather 32u4's you get:
* Measures 2.0" x 0.9" x 0.28" (51mm x 23mm x 8mm) without headers
* Light as a (large?) feather - 9.7 grams
* ESP8266 @ 80MHz with 3.3V logic/power
* 4MB of FLASH (32 MBit)
* Built in WiFi 802.11 b/g/n
* 3.3V regulator with 500mA peak current output
* CP2104 USB-Serial converter onboard with 921600 max baudrate for
* Auto-reset support for getting into bootload mode before firmware
* 9 x GPIO pins - can also be used as I2C and SPI
* 1 x analog inputs 1.0V max
* Built in 100mA LiPoly charger with charging status indicator LED,
can also cut a trace to disable the charger
* Pin #0 red LED for general purpose blinking. Pin #2 blue LED for
bootloading debug & general purpose blinking
* Power/enable pin
* 4 mounting holes
* Reset button
Comes fully assembled and tested, with a USB interface that lets you
quickly use it with the Arduino IDE or NodeMCU Lua. (It comes
preprogrammed with the Lua interpretter) We also toss in some header
so you can solder it in and plug into a solderless breadboard. Lipoly
battery and USB cable not included (but we do have lots of options in
the shop if you'd like!) … more
|Product type||Electronics module|
If you wish to learn more about this product, please visit the manufacturer's website or contact us: email@example.com
Warranty 24 month Bring-in
Limited right of return
Please use our simplified returns and warranty process to return a product or register a warranty case. Returns and warranty
Please use our simplified warranty process to view the warranty period as well as any warranty extensions you may have purchased. This will ensure that your return or warranty case is processed quickly and effectively.
Information subject to change.
Have you tested this product? Share your opinion with the Galaxus community.Rate product
You're not connected to the Internet. Please check that your connection is enabled to keep browsing the site.